Spectra T950 - Connect the HAX Motor Cables

Install the HAX Motor Connect the HAX Motor Cables
March 2015 HAX Motor Replacement—Spectra T950 Library
26
Connect the HAX Motor Cables
1. Locatetheshieldedblackmotorcontrolcableandtheredandblack
powerwiresattachedtotheHAXmotor.
2. Fromtheleftendofthelibrary,usearightangle#2Phillipsscrewdriver
tosecuretheHAXmotor’sredandblackpowerwirestothePhase A
andPhase BconnectorsontheHAXpassiveboard.
 TheredwireconnectstothePhaseAconnector.
 TheblackwireconnectstothePhaseBconnector.
3. ConnectthemotorcontrolcablefromtheHAXmotortotheconnector
adjacenttothePhaseBconnector.
CautionCaution
Make sure that you connect the red and black power cables to the correct
connectors using the screws that were removed earlier. Using different screws or
not connecting the wires correctly can result in serious damage to the library.
Figure 30 Connect the power and control connections to the HAX motor on the floor on
the right side of the left most frame.
HAX sync belt motor connections
Floor of
left-most
frame
power wires
control cable
Important
Make sure that none of the cables press against the HAX motor.