Spectra T950 - Mount the HAX Motor

Install the HAX Motor Mount the HAX Motor
March 2015 HAX Motor Replacement—Spectra T950 Library
21
9. Usinga1/4‐inchwrench,tightenthetensioningspringscrewuntilthe
coilsofthespringbarelytouchandthenloosenthescrewonehalfturn.
10. IfashimwaspresentontheoldHAXmotor,placetheshimoverthe
HAXmotorshaftsothatthetensioningspringstandofffitsintothe
cut‐outintheshim.
Mount the HAX Motor
1. OrienttheHAXmotorwiththetensioningscrewtowardtherightand
themotorgeartowardtheinsideofthelibrary.
Figure 24 Tighten the tensioning spring screw.
Figure 25 Position the HAX motor shim.
HAX motor
mounting bracket
HAX motor shim
Tensioning spring
cut-out