Spectra T950 - Remove the HAX Motor; Disconnect the HAX Motor Cables

Remove the HAX Motor Disconnect the HAX Motor Cables
March 2015 HAX Motor Replacement—Spectra T950 Library
15
a. Slidethefarleftandfarrightmediaguidesforwardandtowardthe
centeroftheshelftoreleasethem.Lifttheguidesofftheshelf.
b. Pulltheshelfstraightouttowardyouandsetitaside.
c. RepeatStep aandStep btoremovethesecondshelf.
REMOVE THE HAX MOTOR
TheHAXmotorismountedontheflooroftheleft‐mostframeofthe
libraryasviewedfromthefront.Usethefollowingsectionstoremovethe
HAXmotor.
Disconnect the HAX Motor Cables
1. IftheVAXcolumnisnotblockingaccesstotheHAXmotorpower
connections,skiptoStep 2onpage 16.Otherwise,fromtheleftendof
thelibrary,slowlypullstraightdownwardontheHAXsyncbeltto
movetheVAXcolumntowardtheright,farenoughsothatyoucan
accesstheHAXmotorpowerconnections.
Caution
Do not push or pull on the VAX column. Doing so can cause alignment problems.
Be careful not to move the HAX sync belt too fast, which can cause it to slip.
Figure 17 Location of the HAX sync belt.
HAX sync belt
VAX column