Spectra T950 - Replace the Access Panels

Complete the Replacement Replace the Access Panels
March 2015 HAX Motor Replacement—Spectra T950 Library
34
Replace the Access Panels
Usethefollowingstepstoinstallaccesspanelsthatwereremoved .
1. Liftthepanelandpositiontheopeningsonthebackofthepanelonthe
hooksonthesidesoftheopeningintheendoftheframe.
2. Whileholdingthepanelsteadywithonehand,slidethepaneldown
intoplace.
3. Usea1/8‐inchAllenwrenchorhex
screwdrivertoinstallthescrewat
thebottomofthesidepanel.
Figure 38 Lift the panel onto the hooks
on the sides of the opening.
Figure 39 Slide the panel
down into place.
Figure 40 Install the screw
to secure the panel.
Back of panel