Spectra T950 - Page 33

Complete the Replacement Reassemble the Left Most Frame
March 2015 HAX Motor Replacement—Spectra T950 Library
33
Install the Fan Assembly (Main Frame Only)
1. Carefullyslidethefan assemblystraightintotheopeningatthebottom
oftheframe.
Note: Makesurethatthetabontheairfilterispressinginonthefilter
sensorswitch.
2. Pushinwardonthebottomofthefanassemblytoseattheconnector
mountedonthebackof
theassembly.
3. Makesurethatthetabonthefilterispressinginontheswitch.
4. Usea#2Phillipsscrewdrivertotightenthefourcaptivescrews
securingthefanassemblytotheframe.
5. Positionthefiltercoveroverthefanassemblyandthenpushfirmly
inwardonthesidesofthecovertosnapitontotheballstudsextending
fromeachsideoftheframe.
Figure 37 Tighten the captive screws to secure the fan assembly to the frame.
Captive screws (4)
Air filter tab
Filter sensor switch