Spectra T950 - Main and Drive Expansion Frame Rear Components

Complete the Replacement Reassemble the Left Most Frame
March 2015 HAX Motor Replacement—Spectra T950 Library
32
2. Installthecableguardandmediacover.
a. Slidethecableguardintotheopeningatthebottomoftheframeso
thatthetabsoneachsidefitthroughthecutouts inthefrontofthe
frame.
b. Alignthecaptivescrewswiththecorrespondingholesintheframe,
thenusea#2Phillipsscrewdrivertotightenthescrewstosecurethe
cableguardtotheframe.
c. Anglethetopedgeofthemediacoverunderthefiltersensor
switchesandthenpositionthemediacoversothatthetabsoneach
sidefitthroughthecutoutsinthefrontof
theframe.
3. Usea#2Phillipsscrewdrivertotightenthefourcaptivescrewsto
securethemediacovertotheframe.ContinuewithInstalltheFan
Assembly(MainFrameOnly).
Figure 36 Install the media cover and cable guard.
Loosen cable
guard screws (2)
Cable guard
Media cover
Loosen media
cover screws (4)
Remove screws (2)
(media frame only)