Spectra T950 - Page 25

Install the HAX Motor Install the HAX Belt Cover
March 2015 HAX Motor Replacement—Spectra T950 Library
25
2. Usinga#2Phillipsscrewdriver,installthesixscrewssecuringtheHAX
beltcovertothetopoftheleftHAXrailsegment.
3. Dependingonthenumberofframesinthelibrary,installtheoneto
threescrewssecuringtheHAXbeltcovertothesideoftheleftHAXrail
segment.
Figure 29 Remove the HAX belt cover from the left HAX rail segment (multi-frame HAX rail segment
shown).
Screws (6)
Screws (up to 3)
Note: This screw may
not be present.