Spectra T950 - Page 17

Remove the HAX Motor Remove the HAX Belt Cover
March 2015 HAX Motor Replacement—Spectra T950 Library
17
2. Fromtheleftendofthelibrary,usea#2Phillipsscrewdrivertoremove
thesixscrewssecuringtheHAXbeltcovertothetopoftheleftHAX
railsegment.
3. Dependingonthenumberofframesinthelibrary,removetheoneto
threescrewssecuringtheHAXbeltcovertothesideoftheleftHAXrail
segment.
4. RemovetheHAXbeltcover
Three-frame or larger library CarefullylifttheHAXbeltcoveroffof
theHAXrailandsetitaside.Onamulti‐segmentcoverthereisalipon
therightendoftheleftsegmentthatfitsunderthe
endofthenext
segment.Slidethecovertowardyoutodisengagethelip.Insomecases
youwillneedtoremovethescrewonthesideofthenextsegmentof
theHAXbeltcoverinordertoremovethefirstsegment.
—OR—
Figure 19 Remove the HAX belt cover from the left HAX rail segment (multi-frame HAX rail segment
shown).
Screws (6)
Screws (up to 3)
Note: This screw may
not be present.