Spectra T950 - Page 28

Complete the Replacement Reassemble the Left Most Frame
March 2015 HAX Motor Replacement—Spectra T950 Library
28
2. Carefullyslidethefanassemblystraightintotheopeninginthebottom
frontoftheframe.
Note: Makesurethatthetabonthefilterispressinginonthefilter
sensorswitch.
3. Pushinwardonthebottomofthefanassemblytoseattheconnector
mountedonthebackoftheassembly.
4. Usea#2Phillipsscrewdrivertotightenthefourcaptivescrewsto
securethefanassemblytotheframe.
5. Positionthefiltercoveroverthefanassemblyandpushfirmlyinward
onthesidesofthecovertosnapitontotheballstudsextendingfrom
eachsideoftheframe.
6. ContinuewithReplacetheAccessPanelsonpage 34.
Figure 32 Tighten the captive screws to secure the fan assembly to the frame.
Captive
screws (4)
Tab
Filter sensor switch