Spectra T950 - Interior Components

Complete the Replacement Reassemble the Left Most Frame
March 2015 HAX Motor Replacement—Spectra T950 Library
30
b. Slidetheshelfintotheframe.Makesurethatthebackedgeofthe
shelffitsintotheslotsintherearmountingtabsandthefronttabsfit
intotheslotsinthefrontoftheframe.
Note: Donotreinstallthemagazinesyouremoved.Youwillreimport
themattheendofthereplacement.
Caution
Make sure that the rear top edge of the shelf fits into both of the rear mounting
slots so that the shelf is level. Incorrectly installing a shelf will cause motion failures.
Important
There may be two sets of mounting slots for the shelves. One set is identified by a
diamond-shaped hole next to the front slots; the other set is identified by a square
hole next to the front slots. Make sure that you install the shelves in the set of slots
identified by the diamond-shaped hole.
Figure 34 Install the media shelves.
Incorrect position
Rear mounting slots
Tabs on the front of the
shelf fit into slots in the
front of the frame.
Correct position