SpectraLink 7622 - Speed Dial; Initiating Ad-Hoc Conference Call; Corporate Directory Calls (System Dependent)

Spectralink 7622/7642 Handset User Guide
Spectralink 76-Series Handset User Guide.docx
April 2023 34
Timesaver:
Alternatively, press the left side of the navigation key to enter the call list. Scroll to the
desired name or number, and press
.
Speed Dial
If you have assigned a number to one of the speed-dialing keys 0-9, do the following:
• Press and hold a key (0-9) for three seconds, until the call is initiated.
Initiating Ad-hoc Conference Call
Ad-hoc Conference call is a system dependent feature and only supported by Cisco Unified
Communications Manager. Contact your system administrator for more information.
To Initiate an Ad-hoc Conference Call
1. Dial number.
2. Press
.
3. Press Options, scroll to New Call, and press Select.
4. Dial a new number. The first call is automatically put on hold while dialing the second
number.
5. Press
.
6. When the second call is connected, press Options, and then press Join in
conference.
7. Press
to end the call.
Note:
The maximum number of participants in an ad-hoc conference is system dependent.
Repeat step 3-6 to add more numbers. Only the initiator of the conference can add
numbers into the conference.
It depends on the PBX settings whether the conference call remains between the other
participants in case you (the initiator) have to leave the conference call and presses
to hang up. Contact your system administrator for more information.
Corporate Directory Calls (System Dependent)