SpectraLink IP-DECT 200 - 3 Broadworks Configuration; Broadworks Device Profile Type Configuration

BROADSOFT PARTNER CONFIGURATION GUIDE – SPECTRALINK IP-DECT SERVER SERIES 20-BD5445-00
©
2019 BROADSOFT INC. PAGE 17 OF 49
3 BroadWorks Configuration
This section identifies the required BroadWorks device profile type for the Spectralink IP-
DECT Servers as well as any other unique BroadWorks configuration required for
interoperability with the Spectralink IP-DECT Server Series.
3.1 BroadWorks Device Profile Type Configuration
This section identifies the device profile type settings to use when deploying the
Spectralink IP-DECT Server Series with BroadWorks.
Create a device profile type for the Spectralink IP-DECT Server Series with settings as
shown in the following example. A separate device profile type should be created for each
Spectralink IP-DECT Server model. The settings shown are recommended for use when
deploying the Spectralink IP-DECT Server Series with BroadWorks. For an explanation of
the profile parameters, see the BroadWorks Device Management Configuration Guide [2].
The device profile type shown provides the Number of Ports (number of SIP lines) setting
for Spectralink IP-DECT 400. For other IP-DECT Server models, create a new device
profile type and set the Number of Ports to match the available number of SIP lines per
model according to the following table.
Model Number of Lines
IP-DECT 200 12
IP DECT 400 30
IP DECT 6500 4096