SpectraLink IP-DECT 200 - Figure 13 Device Profile Type Update for MAC-Based Authentication Using Client Certificate

BROADSOFT PARTNER CONFIGURATION GUIDE – SPECTRALINK IP-DECT SERVER SERIES 20-BD5445-00
©
2019 BROADSOFT INC. PAGE 42 OF 49
Parameter Value Description
Device Access
Protocol
https HTTPS protocol is a must when
using client mutual authentication
with signed certificates.
Device Access Port XSP’s listening port of HTTPS
mutual authentication.
Enter the corresponding TCP port.
Authentication Mode MAC-Based checked MAC-Based authentication
method is used
MAC Address in Client Certificate radio button
selected
MAC address used for
authentication is to be obtained
from the client certificate to
compare to the provisioned values
on the device profiles.
MAC Address Format .*([0-9a-fA-F]{12}).* Regular expression used to parse
the MAC address from the CN field
of the client certificate.
Figure 13 Device Profile Type Update for MAC-Based Authentication Using Client Certificate
5.2.7.3 Change File Authentication Mode to MAC address in Client Certificate
Instructions in this section are only applicable to updating BroadWorks systems with
existing Spectralink IP DECT Server device profile types. Perform corresponding changes
on the authentication mode of all files listed under section 5.2.2.2.2 Define Device Profile
Type Files as shown in the following figure. The regular expression used in MAC Address
Format is: .*([0-9a-fA-F]{12}).*