BROADSOFT PARTNER CONFIGURATION GUIDE – SPECTRALINK IP-DECT SERVER SERIES 20-BD5445-00
©
2019 BROADSOFT INC. PAGE 19 OF 49
4 IP-DECT Server Configuration
This section describes the configuration settings required for the IP-DECT Server
integration with BroadWorks, primarily focusing on the SIP interface configuration. The IP-
DECT Server configuration settings identified in this section have been derived and
verified through interoperability testing with BroadWorks. For configuration details not
covered in this section, see the Provisioning Guide Spectralink IP-DECT Servers and
BroadSoft Device Management [9] for the IP DECT Server.
4.1 Configuration Method
The IP DECT Server Series can be configured with configuration files using the TFTP,
FTP, HTTP(S), or through its embedded Web Interface. The following examples describe
how to set the parameters using a configuration file. The IP DECT Server Series can use
DHCP to obtain an IP address, provisioning server (TFTP, FTP or HTTP(S)), and other
network settings. These settings can also, be configured manually through the embedded
Web Interface. If provisioning is used the IP DECT Server Series should be configured to
load the configuration file each time it resets or re-synchronizes.
Configuration Files
IP-DECT Server Series Configuration
Files
Level Description
14218500-ipdect-firmware-pcs18Ba.bin System Contains the device firmware load.
14218500-ipdect-firmware-
pcs18Ba.bin.ver
System Contains the device’s firmware version.
<IP DECT Server MAC
address>config.xml
Example: 0013d1813a18-config.xml
System Contains configurable parameters that
apply to an individual device in a
deployment.
<IP DECT Server MAC
address>users.xml
Example: 0013d1813a18-users.xml
Subscriber Contains the list of users (handsets) to
configure for an individual device in a
deployment.
4.2 System Level Configuration
This section describes system-wide configuration items that are generally required for
each IP-DECT Server Series to work with BroadWorks. Subscriber-specific settings are
described in the next section.
4.2.1 Configure Network Settings
System Configuration File <IP DECT Server MAC address> config.xml
XML File Tag Description
network.bootproto
Method used to assign an IPv4 address. Choice of
either dhcp or static assigned.
network.ipaddr
IPv4 address
Not required if DHCP assigned
network.netmask
IPv4 netmask.
Not required if DHCP assigned.
network.gateway
IPv4 gateway.
Not required if DHCP assigned.
To Next Page
Loading...
