BROADSOFT PARTNER CONFIGURATION GUIDE – SPECTRALINK IP-DECT SERVER SERIES 20-BD5445-00
©
2019 BROADSOFT INC. PAGE 20 OF 49
System Configuration File <IP DECT Server MAC address> config.xml
XML File Tag Description
network.dns1
Primary DNS server IPv4 or IPv6 address.
Not required if DHCP assigned.
network.dns2
Secondary DNS server IPv4 or IPv6 address.
Not required if DHCP assigned.
network.vlan
Choose your VLAN Settings (optional).
4.2.1.1 Configure IPV6 Settings
XML File Tag Description
network.ipv6.method
Specifies the method used to obtain an IPv6
configuration.
Values:
“slaac” Use router advertisements to obtain an
IPv6 address.
“dhcp” Use DHCPv6 to obtain an IPv6 address.
“static” Configure IPv6 address and gateway
manually.
“disabled” Disable IPv6 support.
network.ipv6.ipaddr
Specify a static IPv6 address including the prefix
length.
Values: <IPv6 address>/prefix.
Example: 3000::2/64.
Not required if automatically assigned.
network.ipv6.gateway
Specify a static IPv6 gateway.
Values: <IPv6 address>.
Example: 3000::1.
Not required if automatically assigned.
4.2.2 Configure SIP Interface Settings
XML File Description
sip.transport
Set the transport protocol to UDP, TCP or TLS.
Values: udp, tcp or tls.
Default: udp.
sip.defaultdomain
Set the IP DECT Server Series SIP server to the
Fully Qualified Domain Name (FQDN) of the
BroadWorks Application Server cluster.
The domain must match the domain configured for
the BroadWorks subscriber’s line/port domain.
sip.proxy.domain
Set the Outbound Proxy to the Session Border
Controller (SBC) if one is deployed between the IP
DECT Server Series and BroadWorks.
If there are redundant SBCs, set it to the FQDN for
the SBC cluster.
To Next Page
Loading...
