BROADSOFT PARTNER CONFIGURATION GUIDE – SPECTRALINK IP-DECT SERVER SERIES 20-BD5445-00
©
2019 BROADSOFT INC. PAGE 33 OF 49
Browse to System → Resources → Identity/Device Profile Types and perform a search to
find the Spectralink device profile type(s) created in section 3.1 BroadWorks Device Profile
Type Configuration or add the device profile type for each model using the settings from
section 3.1 BroadWorks Device Profile Type Configuration if they do not exist.
Configure the device profile type Signaling Address Type, Standard and Advanced options
settings to match the settings in section 3.1 BroadWorks Device Profile Type
Configuration.
Configure the device profile type Device Management options as shown in section 5.2.2.1
Configuration Method 1: Import.
The following subsections identify the required settings specific to Device Management.
5.2.2.2.2 Define Device Profile Type Files
This section describes the BroadWorks Device Management configuration necessary to
identify the configuration files and other files that the Spectralink IP-DECT Server Series
download.
Configuration templates, firmware, and other files the IP-DECT Server uses must be
uploaded to BroadWorks. Download the Spectralink IP-DECT Server Series CPE kit from
BroadSoft Xchange at xchange.broadsoft.com. Extract the configuration files from the
Configuration Files folder of CPE kit. Obtain the firmware files directly from Spectralink.
The following table identifies the Spectralink configuration files distributed with the
PCS18Ba CPE kit.
File Name CPE Kit Template File Name File Type Description
%BWMACADDRE
SS%-config.xml
%BWMACADDRESS%-
config.xml.template
Device-specific This file contains all IP-DECT system
configurations.
%BWMACADDRE
SS%-users.xml
%BWMACADDRESS%-
users-12.xml.template
%BWMACADDRESS%-
users-30.xml.template
%BWMACADDRESS%-
users-1024.xml.template
Device-specific This file contains all IP-DECT user
configurations. There are two
template files included for different
system capacity.
IP-DECT 200: 12
IP-DECT 400: 30
IP-DECT 6500: 1024*
*BroadWorks DM only supports up to
1024 ports.
The following table identifies other files that the Spectralink IP-DECT Server downloads
from the server or uploads to the server. These files are not provided in the CPE kit and
must be obtained from Spectralink.
File Name File Type Description
14218500-ipdect-firmware-%IP-
DECT-FWVERSION%.bin
Static Firmware file for the IP-DECT Server.
14218500-ipdect-firmware-%IP-
DECT-FWVERSION%.bin.ver
Static Firmware version file for the IP-DECT Server.
Browse to System → Resources → Identity/Device Profile Types → Files and
Authentication to add the files as described in the following subsections.
5.2.2.2.2.1 %BWMACADDRESS%-config.xml
Add the %BWMACADDRESS%-config.xml file to the device profile type with the settings
shown in Figure 6.
To Next Page
Loading...
