BROADSOFT PARTNER CONFIGURATION GUIDE – SPECTRALINK IP-DECT SERVER SERIES 20-BD5445-00
©
2019 BROADSOFT INC. PAGE 31 OF 49
There are two BroadWorks device profile configuration methods described: import and
manual. The import method takes a DTAF as input and builds the BroadWorks device
profile type(s) automatically. The manual method takes the administrator through the
steps to manually add and configure the device profile type(s).
The import method should be used if all of the following prerequisites are met:
The BroadWorks Release is 17.0 or later.
The device profile type(s) being imported do not already exist on the system. (If either
a previous import or manual configuration was done, then the import fails.)
There is a DTAF file available for import with a BroadWorks release level that is the
same as or prior to the release to which it is being imported. If the DTAF file is at a
release level later than the release being imported to, then the import can fail.
Otherwise, use the manual method.
For more detailed instructions, refer to the BroadWorks CPE Kit Usage Guide [8] and the
BroadWorks Device Management Configuration Guide [2].
5.2.2.1 Configuration Method 1: Import
This section identifies the steps necessary to make use of the Device Management import
feature to configure BroadWorks to add the Spectralink IP DECT Server as a Device
Management-enabled device type. Also, see the BroadWorks CPE Kit Usage Guide [8].
Download the Spectralink IP DECT Server Series CPE kit from BroadSoft Xchange at
xchange.broadsoft.com. Extract the DTAF file(s) from the CPE kit. These are the import
files. Repeat the following steps for each model you wish to import.
1) Log in to BroadWorks as an administrator.
2) Browse to System → Resources → Identity/Device Profile Types and then click
Import.
3) Select Browse to find the extracted DTAF file for the model and then click OK to start
the import.
After the import finishes, complete the following post-import configuration steps:
4) Browse to System → Resources → Identity/Device Profile Types.
5) Perform a search to find the imported Spectralink device profile type, Spectralink IP
DECT Server.
6) Browse to the Profile page and change the Device Management Device Access
FQDN to your Xtended Services Platform (XSP) or XSP cluster address.
To Next Page
Loading...
