Using GMOS 25
STOP TIMER: 10s IDLE
LINE WIDTH 100M
M.DISP: LAP TIME
S.DISP: BEST LAP
FREEZE TIME: 10 SEC
GO TO DRIVE MODE
EXIT TO TIMER
Press SELECT to choose the length of time the
Timer is to be idle for before GMOS stops the Timer
and log recording. You can choose a value among 0,
10, 20, 30, 180 and 240.
• You can stop the Timer any time by pressing
either of the keys. If you press MENU, GMOS will
stop the Timer AND enter Laptimer Menu.
Press
SELECT
to set the Finish Line at 60M or 100M
long.
Press SELECT to designate what is to be used as
Main Display between Lap Time and Session Time .
Press SELECT to designate what is to be used as
Sub Display among Best Lap with time gap (time gap
displayed after a lap is complete), Last Lap, and Sec-
tor Time (if there are Sector Lines available).
Press SELECT to choose a time length the Main Dis-
play and Sub Display are to be held when a record is
updated. You can select a value among 10, 20, 30,
45, 60 and 90.
Press SELECT to go to Drive Mode. The system will
ask you “
SURE?”. Press SELECT to confirm. Other-
wise, press MENU to cancel.
Press SELECT to exit Laptimer Menu and go back to
Timer.
To Next Page
Loading...
