22
SPEKTRUM DX10t • RADIO INSTRUCTION MANUAL
EN
11 PARAMETER PROGRAMMING THE FUNCTIONS OF A SAILPLANE MODEL IN
THE FUNCTION LIST
Servo setup with Submenu
Travel
Sub-Trim
Reverse
Speed
Absolute Travel
Balance
Please refer to wing-type model programming for
instructions.
11-2 Dual Rate and Exponential
Please refer to wing-type model programming for
instructions.
11-3 Throttle Cut
Please refer to wing-type model programming for
instructions.
This function is only active if the Sailplane has a motor.
The default setting of this function is inhibited.
11-4 Throttle Curve
Please refer to wing-type model programming for
instructions.
11-5 Mixes
Depending on the wing type you selected in the Function
List, different mixes are available.
Aileron to Rudder
Aileron to Flap Position
Elevator to Flap
Flap to Elevator
This is for wing type 2 Aileron , 2 Flaps
On some wing types some mixes are not active and
cannot be selected. Mixing is shown in percentages.
There are 6 optional programmable mixes that are
available.
11-6- Camber Presets
This menu is active when Flaps are selected at wing type.
Adjust the numerical values for left and right aileron
and left and right ap. Do the same for the elevator.
Optionally, adjust the speed from 0 – 30 seconds.
11- 7 Camber System
In this menu, you adjust the values for Spoilers and
Aileron from -100 and +100.
11-8 Range Test
Please refer to wing-type model programming for
instructions.
11-9 Timer
Please refer to wing-type model programming for
instructions.