SPIDER MINI - Preparing the Spider MINI Machine; Machine Delivery and Unpacking

Operation manual – Spider MINI
21 / 53 rev. 02-01-10-2011
8. PREPARING THE MACHINE
8.1. MACHINE DELIVERY TO A DEALER OR CUSTOMER
From the manufacturer the mower is delivered with complete fillings of engine oil and hydraulic oil,
but without fuel in the fuel tank.
Operator training should take place during the installation of the product and certainly before the operator starts
to use the product.
To take the mower off a pallet / crate:
 Place the palette with the mower on a level surface
 Carefully remove the upper boards of the crate and take out all accessories & the remote control.
Disassemble the side boards of the crate
 Release the attachment fastening the mower to the pallet, remove transportation wrapping. Recycle
these wraps.
 Thoroughly examine the mower for possible damage and missing parts from the delivery. If necessary,
contact the transporting company with your claim.
 Before driving down from the pallet raise the mowing mechanism to the upper position
 Place boards in front of the wheels in the direction, in which you expect to drive the mower from the
pallet to the ground. Put at least 1 litre/0,3 gallon of fuel to the tank and attach cables onto the battery.
While starting, follow instructions in chapter 9.2.
 Slowly move the forward/reverse joystick to correspond with the direction you want to move the mower.
The arrow on the wheel legs indicates forward.
 Slowly drive down to the ground and stop the engine
 While unpacking, assembling and preparing the mower, do not engage the mower blade.
Parts of delivery:
 SPIDER mower
 Mower ignition key (X2)
 Gel battery (12V)
 Remote control + 2 x AA battery
 Operation manual
 Remote control key (X2)
 Engine user´s and maintenance manual
 Remote control operation manual
 Copy of CE declaration of conformity for the mower
 Copy of CE declaration of conformity for the NBB remote control
During the first start there may be a lack of fuel in the fuel system and the starting procedure may
need to be repeated several times. Do not engage the starter for more than 5 seconds. Wait for at
least 1 minute between individual attempts to start the engine.
If you have a suitable lifting device available, place the lifting hooks / eyes on spots marked with the
chain symbol and lift the mower by about 15 cm / 6 inches, move the pallet away from the mower
and lower the mower to the ground.