Operation manual – Spider MINI
9 / 53 rev. 02-01-10-2011
2. SAFETY INSTRUCTIONS
This safety symbol indicates important safety messages in this manual. When you see this
symbol, be alert to the possibility of injury, carefully read the message that follows, and inform
other operators.
Safety Instructions
Do not enter or reach under the machine if it is lifted and not sufficiently supported. The machine should
be supported on places marked by the symbol of a chain.
The mower should only be transported in a container or on a trailer.
Check bolt torques at regular intervals. The first check should be done after 8 operating hours. Pay
attention to the attachment of the cutting blade and the proper bolt torque. Use a torque wrench and a
specified torque of 60Nm.
The blade hub bolts and the blade bolts must not show any signs of damage or wear. The bolts must be
complete. The blade must be undamaged, evenly worn and adequately sharp. The bolts should be
tightened with a torque of 60Nm.
If you are driving the mower outside the working area with disengaged blades, always set the maximum
height of cut otherwise the blade may get damaged.
Keep the product clean after use. Do not use gasoline or similar oil products for cleaning.
Do not reach with your hands or feet inside the mower, under the mowing deck, under the engine
covers or into the transmission system.
If you are forced to reach under the machine, wait until all rotating parts (including the engine) stop.
Attention, it takes some time before blade runs down! The run-down time depends on the state and
wear of the brake/clutch. Have the brake checked at regular intervals at an authorised servicing facility.
While operating, wear closed shoes and work clothing. Do not wear loose clothes that could get caught
by the machine, short trousers or light shoes.
A local risk assessment should determine the need for a face shield.
Do not operate the machine after drinking alcohol or using medication influencing perception.
Before starting the engine make sure that the mower blade is engaged (for mowing operation) or
disengaged (for transport). The blade may be dis-/engaged and height of cut adjusted only if the engine
is shut off. When starting the engine always step aside far enough to be protected against object
accidentally thrown from the mower and to be able to stop the mower in case of an emergency. Do not
enter the path of the mower.
While operating the mower make sure that the mower is clearly visible at all times and within the range
of the remote control unit and that you can clearly recognize dangerous situations and react to them
properly. Do not abuse the maximum reach of the remote control.
When using the mower, follow all general work safety regulations.
Work with the mower may only be started if the mower is not damaged by previous operation.
Do not change the engine tuning, especially the engine speed regulator. Do not modify the exhaust
pipe.
Do not use the mower if there is less than 30% of fuel in the fuel tank.
Do not move the mower by means of towing it behind another machine.
Operating Environment
The machine should only be used by persons over 18 years of age, who have been acquainted with the
machine and the user’s manual .The remote control (further referred to as ”RC”) is considered a part of
the machine
The user’s manual must be stored in a place permanently accessible to the operator and must be
available to him at all times.
Do not allow children or unauthorised persons use the product.
Before starting to operate the machine, you have to be familiar with all the symbols next to the controls
and indicators used on the mower and the RC.
Pay special attention to the stopping and shutting-off of the engine and to the emergency shutting-off of
To Next Page
Loading...
