SRAM RockShox SIDLuxe Select+ 2P User Manual

19
Lever Installation
Install the flat point screw onto the top of the frontside of the eyelet
until it is flush with the eyelet.
Install the lever. Install the lever limit screw until it bottoms out.
Pressurize the damper body.
If you have the proper fill equipment, you may substitute air with
nitrogen.
Once you have pressurized the shock, remove the air valve adapter
tool from the air fill port before removing it from the shock pump.
Separating the pump from the adapter first will cause all of the air to
escape from the shock.
Install the damper air/nitrogen fill port cap.
This concludes the eyelet controls/damper change for SIDLuxe.
4
2 mm
1.5 mm
5
6
Shock pump 500 psi SIDLuxe adapter tool
Schrader valve tool
7

SRAM RockShox SIDLuxe Select+ 2P Specifications

General

Brand	SRAM
Model	RockShox SIDLuxe Select+ 2P
Category	Bicycle Accessories
Language	English