SRAM RockShox SIDLuxe Select+ 2P User Manual

23
Backside Remote Installation
Backside Remote Installation
The procedure for 2P and 3P remote installation is the same. The 2P and 3P lock cams and valve cups are not interechangeable and require unique
parts. Consult the RockShox Spare Parts Catalog at www.sram.com/service for parts.
NOTICE
To change from a 2P to a 3P control/damper system, or vice versa, requires a different valve cup and new lever or remote cams. See the
Lever and Remote Damper Change and Mid-Tune Valve Cup Change.
Install the inner cam bushing onto the lever lock cam.
Install one end of the torsion spring into the small hole on the lock
cam. Install the other end of the torsion spring into the small hole on
preloader.
Apply a liberal amount of grease to the spring and cam assembly.
Install the cam/spring/preloader assembly into the backside of the
eyelet.
Install the limit screw into the front side of the eyelet.
Backside Backside
1
Backside Grease
2
3
2 mm

SRAM RockShox SIDLuxe Select+ 2P Specifications

General

Brand	SRAM
Model	RockShox SIDLuxe Select+ 2P
Category	Bicycle Accessories
Language	English