30
SIDLuxe Service
SIDLuxe Service
Prior to servicing your rear shock, remove it from the bicycle frame according to the bicycle manufacturer's instructions. Once the shock is removed
from the bicycle, remove the mounting hardware before performing any service (see the Shock Eyelet Service section).
50/200 Hour Service Air Can Removal
To record your adjustment settings, rotate the red rebound adjuster To record your adjustment settings, rotate the red rebound adjuster
counter-clockwise until it stops, while counting the number of detent counter-clockwise until it stops, while counting the number of detent
clicks. This will assist you with post-service set up.clicks. This will assist you with post-service set up.
Remote: The blue compression circuit is unlocked by default once the
remote cable is removed.
RL: Rotate the blue compression lever to the unlocked position.
Record your air pressure setting to assist with post-service set up. Record your air pressure setting to assist with post-service set up.
Remove the air valve cap by hand. Lightly depress the Schrader valve Remove the air valve cap by hand. Lightly depress the Schrader valve
and slowly release all air pressure from the air can. and slowly release all air pressure from the air can.
⚠ CAUTION
Slowly release the air from the air can to make sure the air is removed
from both chambers. Quickly releasing the air can trap air in the
negative chamber and cause the air can to forcefully eject from the
shock upon disassembly.
Do not disassemble a pressurized shock, this can cause suspension
fluid or debris to forcefully eject from the shock. Wear safety glasses.
Use a Schrader valve tool to remove and reinstall the valve core from Use a Schrader valve tool to remove and reinstall the valve core from
the valve body to make sure all air has been removed.the valve body to make sure all air has been removed.
Remote 2.5 mm
1
RL 2.5 mm RL
2
Small hex
Schrader valve tool
To Next Page
Loading...
Need help?
General
