21
In/Out Remote Installation
Rotate the preloader 360° clockwise until the hole is aligned with the
hole in the eyelet again. Hold in place and install the limit screw until it
is flush with the eyelet.
Install the cable hanger. Tighten the cable hanger bolt.
Install the remote cable pulley. Install the pulley limit screw until it
bottoms out.
Pressurize the damper body.
If you have the proper fill equipment, you may substitute air with
nitrogen.
Once you have pressurized the shock, remove the air valve adapter
tool from the air fill port before removing it from the shock pump.
Separating the pump from the adapter first will cause all of the air to
escape from the shock.
3 mm 360 ° 3 mm 1.5 mm
4
In: 2 mm 1 Nm (8 in-lb) Out: 2 mm 1 Nm (8 in-lb)
5
6
In 1.5 mm Out 1.5 mm
7
Shock pump 500 psi SIDLuxe adapter tool
To Next Page
Loading...
Need help?
General
