SRAM RockShox SIDLuxe Select+ 2P User Manual

27
Mounting Hardware Removal
Insert the threaded rod through the shaft eyelet until the push pin rests Insert the threaded rod through the shaft eyelet until the push pin rests
against the bushing pin. against the bushing pin.
Thread the large, open end of the catcher along the rod until it rests on Thread the large, open end of the catcher along the rod until it rests on
the end spacer. the end spacer.
Clamp the catcher in a vise or hold it secure with a 13 mm open Clamp the catcher in a vise or hold it secure with a 13 mm open
end or adjustable wrench.end or adjustable wrench.
NOTICE
Do not scratch the air can as you turn the wrench.
Use a second 13 mm wrench to thread the push pin along the rod until Use a second 13 mm wrench to thread the push pin along the rod until
it stops against the end spacer. it stops against the end spacer.
Unthread the push pin from the threaded rod to remove the end Unthread the push pin from the threaded rod to remove the end
spacer and the bushing pivot pin.spacer and the bushing pivot pin.
If the bushing pin does not remove easily, reinsert the threaded rod If the bushing pin does not remove easily, reinsert the threaded rod
and push pin back through the eyelet shaft.and push pin back through the eyelet shaft.
Thread the large, open end of the catcher along the rod until it rests Thread the large, open end of the catcher along the rod until it rests
against the shaft eyelet. against the shaft eyelet.
Use a 13 mm wrench to thread the push pin along the rod until it stops Use a 13 mm wrench to thread the push pin along the rod until it stops
against the end spacer.against the end spacer.
2
3
13 mm 13 mm
13 mm 13 mm
4

SRAM RockShox SIDLuxe Select+ 2P Specifications

General

Brand	SRAM
Model	RockShox SIDLuxe Select+ 2P
Category	Bicycle Accessories
Language	English