51
Air Can Installation
Remove the shock from the vise. Turn it over and clamp the damper
body eyelet in the vise.
Stabilize the air can with a strap wrench to prevent it from rotating.
Tighten the air can.
Remove the shock from the vise. Spray isopropyl alcohol on the shock Remove the shock from the vise. Spray isopropyl alcohol on the shock
and clean it with a shop towel.and clean it with a shop towel.
Install the sag indicator o-ring. Install the sag indicator o-ring.
5
13 mm 10 N·m (90 in-lb)
6
7
To Next Page
Loading...
