SRC RANGER 4000 S - Chapter 2: System Installation; Mounting the Controller

RangerSInstallationandtroubleshooting
5
Chapter2:SystemInstallation
MountingtheController
ThoughtheRanger4000Sisdesignedtoresistbothrainanddirectsun
light,youshouldplaceitinafriendlierenvironmentifpossible.Installing
theRanger4000Sinsideautilityroomorashedistheperfectsolution,but
ifthisisnotpossible,trytoplaceitsomewheredryandoutofsight.
Furthermore,makesurethatyouplacethecontrollerinalocationthat
meetstheserequirements:
• Thecontrollermusthaveaccessto230VAC.
• Youmustbeabletoconnectallcablestothecontrolleratthe
location.
Tominimizeelectromagneticinterference,makesurethatthecontrolleris
placedatleast4,5mawayfromanyhigh‐drawmotorslikeairconditioners,
refrigerators,poolpumpsetc.
3 Useapentoputmarksonthewallthroughtheholeinthebackof
thecontrollercabinet.
4 Ifyou'replacingthecontrolleronaconcretewall,takedownthe
controller,drilloutthehole,putinthewallanchor,andputbackthe
controlleronthewall.
5 Fastenthescrewinthewallthroughtheholesinthebackofthe
controllercabinet.
Nowthecontrollershouldbemountedfirmlyonthewall.Aftermounting
thecontroller,it'stimetoconnectthepowerandconnectboards‐follow
theinstructionsinthenextsectiontodothis.