SRC RANGER 4000 S - Setting the Flow Sensor Adjustment; Adjusting the Flow Sensor Input

RangerSInstallationandtroubleshooting
32
ActualFlow=K*(Pulses+Offset)
Aboutthetwovaluesyouneedtoenter:
• The"Offset"valueistocorrecttheinputfromyoursensor.
•
• The"K"valuecanbelookedupinthedatasheetforyoursensor.
4 Usetheitemselectorstoenteryourvaluesandpushthe ENTER
buttontosaveyoursettings.
SettingtheFlowSensorAdjustment
Ifyouwanttocalibrateyourflowsensor,youcanusethesensor
adjustmenttomultiplythevaluesfromyoursensorwithanythingbetween
0.00and9.99.
Thiscomesinhandyifyouhaveastandardsensorthatbehavesslightly
differentthanthebuilt‐inprofilecalculates.
Adjustingtheflowsensorinput
1 Turnthedialto ADVANCED ,usetheitemselectorstoscrolltoitem
number
3. FloGuard ,andpushthe ENTER button.
Nowyou'llseethisdisplay: