Using IAR Embedded Workbench® for ARM UM1467
11/46 Doc ID 022172 Rev 1
6 Using IAR Embedded Workbench® for ARM
6.1 Building an existing EWARM project
The following is the procedure for building an existing EWARM project.
1. Open the IAR Embedded Workbench® for ARM (EWARM).
Figure 3 shows the basic names of the windows referred to in this document.
Figure 3. IAR Embedded Workbench IDE (Integrated Design Environment)
2. In the File menu, select Open and click Workspace to display the Open Workspace
dialog box. Browse to select the demonstration workspace file and click Open to launch
it in the Project window.
3. In the Project menu, select Rebuild All to compile your project.
To Next Page
Loading...
