6 Quick start
This chapter describes how to start a development quickly using the STM32MP135F-DK.
Before installing and using the product, accept the evaluation product license agreement from the www.st.com/
epla webpage.
Before the first use, make sure that no damage occurred to the product during shipment and check that:
• All socketed components are firmly secured in their sockets
• Nothing is loose in the board plastic bag or in the box
The STM32MP135 Discovery kit is a low-cost and easy-to-use development kit to quickly evaluate and start a
development with an STM32MP135 microprocessor in a TFBGA320 package.
To start using the STM32MP135F-DK, follow the steps below:
1. Check the boot mode switch positions on the board, as shown in Table 5.
2. For a correct identification among the host PC device interfaces, before connecting the board, install the
USB driver available on the www.st.com website.
3.
To power the board, connect its USB Type-C
®
connector CN12 to a 5 V / 3 A USB Type-C
®
charger with its
cable. As a result, the green LED LD1 (5 V PWR LED) and the blue LED LD3 light up, and the LED LD5
(ST-LINK LED) blinks.
4. The software demonstration and the several software examples that allow the user to use the Discovery kit
features are available at the www.st.com/stm32mp1 webpage.
5. Develop an application using the available examples.
UM2993
Quick start
UM2993 - Rev 2
page 7/42
To Next Page
Loading...
Need help?
General
