STA-RITE IntelliPro Variable Speed - Advanced Settings and Configuration

IntelliPro
®
Pump Menus
The IntelliPro
®
pump menu descriptions are as follows:
Settings: Pump Address
The pump address needs to be changed when there is more than one IntelliPro
®
pump on an automation
system. Addressing the pump allows the automation system to know which pump to send a command
to. The “Pump Address” setting is used when the IntelliPro
®
pump is connected via the RS-485 COM
port to an IntelliTouch
®
, EasyTouch
®
, SunTouch
®
or IntelliComm
®
system. The default pump address
is #1. When connected to EasyTouch
®
, SunTouch
®
or IntelliComm
®
the pump only communicates with
address #1. The pump address can be set from 1-16. However, IntelliTouch
®
can communicate to four
(1-4) IntelliPro
®
pumps. Note: IntelliPro
®
pumps cannot be connected in series with other pumps.
To access the Settings menu:
1. Be sure the green power LED is on and the pump is stopped.
2. Press the Menu button. “Settings” is displayed.
3. Press the Select button. “Pump Address” is displayed. The Factory default setting is address “1.”
4. To change the pump address, press the Select button. The fi rst digit “1” selected.
5. Press Up or Down arrow button to change the address number from 1-16.
6. Press the Enter button to save the setting. To cancel any changes, press the Escape button to
exit edit mode without saving.
7. Press the Escape button to exit.
Settings: Set Time
Use “Set Time” to set the IntelliPro
®
system time. The IntelliPro
®
system clock controls all scheduled
start and stop times, functions, and programmed cycles. The system clock can store the correct time for
up to 96 hours after power is shut off. The IntelliPro
®
will retain the time memory for 96 hours before a
reset is needed.
To access the Set Time menu:
1. Check that the green power LED is on.
2. Press the Menu button. “Settings” is displayed.
3. Press the Select button. “Pump Address” is displayed.
4. Use the Up or Down arrow button to scroll to “Set Time”
5. Press the Select button. The cursor will appear in the Minutes column.
6. Press Up or Down arrow button to set the time.
7. Press the Enter button to save the setting. To cancel any changes, press the Escape button to
exit edit mode without saving.
8. Press the Escape button to exit.
IntelliPro
®
Variable Speed Pump Installation and User’s Guide
9