Entering Password
• When Password Protection is enabled the press of any button other than the speed button will
cause the Screen to ask for a Password.
• To enter password use the left and right arrows to move the cursor and the Up and Down
arrow button to scroll through the digit, then press the Enter button to confi rm.
Password Protection
Password: The default for this setting is disabled, which means the pump does not have password
protection. When this feature is enabled, for a preset amount of time after the last button is pressed,
the pump’s display will prompt for the password before allowing access to the pump’s control panel
and buttons The password must be a four (4) numeric digit password. Write down the password and
keep in a secure place.
• When the pump is password protected the pump can always be turned off by pressing the
Start/Stop button.
• When running the pump in manual mode it can not be turned back on with the press of the
Start/Stop button.
• Pressing the Start/Stop button when the pump is off will return it back to the Running
Cycles Mode and will run at the next scheduled run time. If the present time is within the
scheduled run time the pump will run the scheduled speed.
• All functions including programming are disabled in Password Protection Mode.
• If any button other than the Start/Stop button is pressed, the screen reads Enter Password.
• When Password Protection is enabled there is a key icon displayed in the upper left side of
the LCD.
IntelliPro
®
Variable Speed Pump Installation and User’s Guide
13
12:15
1100 RPM
Actual Speed
Running Speed 1
Key Lockout
Icon
750 RPM
To Next Page
Loading...
