Stanley HY 227/10/5 - Disposal and Recycling; Troubleshooting Guide

18
G
B
 2SHQJHQWO\WKHGUDLQYDOYH
 .HHSWKHFRPSUHVVRUWLOWHGXQWLODOOPRLVWXUHKDVEHHQUHPRYHG
 &ORVHWKHGUDLQYDOYH
Warning!
The condensation water from the pressure vessel will
contain residual oil. Dispose of the condensation water in an
environmentally compatible manner at the appropriate collection
point.
7.3 Safety valve (ref. G)
The safety valve has been set for the highest permitted pressure of the
SUHVVXUHYHVVHO,WLVSURKLELWHGWRDGMXVWWKHVDIHW\YDOYHRUUHPRYHLWV
VHDO$FWXDWHWKHVDIHW\YDOYHIURPWLPHWRWLPHWRHQVXUHWKDWLWZRUNV
ZKHQUHTXLUHG3XOOWKHULQJZLWKVXIILFLHQWIRUFHILJXQWLO\RXFDQ
KHDUWKHFRPSUHVVHGDLUEHLQJUHOHDVHG7KHQUHOHDVHWKHULQJDJDLQ
7.4 Checking the oil level
The compressor is life lubricated. In any case, periodically check the
oil level.
3ODFHWKHFRPSUHVVRURQDOHYHODQGVWUDLJKWVXUIDFH5HPRYHWKHRLO
GLSVWLFN)LJDQGZLSHWKHGLSVWLFN5HLQVHUWWKHGLSVWLFNLQWRWKH
ILOOHURSHQLQJDVIDUDVLWZLOOJR3XOORXWWKHGLSVWLFNDQGUHDGRIIWKH
RLOOHYHO7KHRLOOHYHOPXVWEHEHWZHHQWKHWZRPDUNV0$;DQG0,1
RQWKHRLOGLSVWLFN)LJ
Warning!
The possible topping up of oil should be done with extreme caution.
Should it be necessary to top up, at the end of the operation, the oil level
should NOT exceed the mark MAX on the oil dipstick.
Use SAE 40 mineral oil. Never mix different grade oils.
7.5 Storage
Warning!
Pull the mains plug out of the socket and ventilate the appliance
and all connected pneumatic tools.
Switch off the compressor and make sure that it is secured in
such a way that it cannot be started up again by any unauthorized
person.
Warning!
Store the compressor only in a dry location which is not
accessible to unauthorized persons.
Always store upright, never tilted!
8. DISPOSAL AND RECYCLING
The unit and its accessories are made of various types of material,
VXFKDVPHWDODQGSODVWLF
'HIHFWLYHFRPSRQHQWVPXVWEHGLVSRVHGRIDVVSHFLDOZDVWH$VN\RXU
GHDOHURU\RXUORFDOFRXQFLO
9. TROUBLESHOOTING GUIDE
Note: Remove power source and drain tank pressure prior to making any repairs or adjustments.
FAULT CAUSE REMEDY
Leakage of air from the valve of the
SUHVVXUHVZLWFKZLWKWKHFRPSUHVVRURII
Check valve that, due to wear or dirt on the
VHDOGRHVQRWSHUIRUPLWVIXQFWLRQFRUUHFWO\
8QVFUHZWKHKH[DJRQDOKHDGRIWKHFKHFN
valve, clean the valve seat and the special
UXEEHUGLVNUHSODFHLIZRUQ5HDVVHPEOH
DQGWLJKWHQFDUHIXOO\
5HGXFWLRQRISHUIRUPDQFH)UHTXHQWVWDUW
XS/RZSUHVVXUHYDOXHV
([FHVVLYHSHUIRUPDQFHUHTXHVWFKHFNIRU
DQ\OHDNVIURPWKHFRXSOLQJVDQGRUSLSHV
,QWDNH¿OWHUPD\EHFORJJHG
5HSODFHWKHVHDOVRIWKH¿WWLQJFOHDQRU
UHSODFHWKH¿OWHU
The compressor stops and restarts
DXWRPDWLFDOO\DIWHUDIHZPLQXWHV
Tripping of the thermal cutout due to
RYHUKHDWLQJRIWKHPRWRU
&OHDQWKHDLUGXFWVLQWKHFRQYH\RU
9HQWLODWHWKHZRUNDUHD
After a few attempts to restart, the
FRPSUHVVRUVWRSV
Tripping of the thermal cutout due to
RYHUKHDWLQJRIWKHPRWRUUHPRYDORIWKH
plug with the compressor running, low
SRZHUYROWDJH
$FWLYDWHWKHRQRIIVZLWFK9HQWLODWHWKHZRUN
DUHD:DLWDIHZPLQXWHV7KHFRPSUHVVRU
ZLOOUHVWDUWLQGHSHQGHQWO\
The compressor does not stop and the
VDIHW\YDOYHLVWULSSHG
Irregular functioning of the compressor or
EUHDNDJHRIWKHSUHVVXUHVZLWFK
Remove the plug and contact the Service
&HQWHU
Any other type of operation must be carried out by authorized Service Centers, requesting original parts. Tampering with the machine
may impair its safety and in any case make the warranty null and void.
Warranty and repair.
,QWKHHYHQWRIGHIHFWLYHJRRGVRUUHTXLUHPHQWVIRUVSDUHSDUWVNLQGO\FRQWDFWWKHVDOHVSRLQWZKHUH\RXPDGH\RXUSXUFKDVH