Display
QB Expert Alpha Controller
22
Use the up/down arrow keys and the interactive OK button, or the Toggle button, or the number keys, to select
the action required.
Export Rundowns will transfer all fastening cycle data to the USB memory stick after choosing a file name.
Export Trace will transfer fastening cycle trace data to the USB memory stick after choosing a file name. Choose
between the selected trace, the number of traces in the population size or all traces to be exported. When
exporting the SELECTED trace it exports as a comma seperated value file. If POPULATION or ALL are selected the
appropriate number of traces are placed into a zip file before exporting. If selecting All, be aware it will take a
significant amount of time before all traces are put into the zip file and exported.
Delete Rundowns will delete all fastening cycle and trace data from the QB Alpha Expert controller. This action
cannot be undone.
Press the interactive YES button to delete the data. Press the interactive NO button to cancel the delete action.
Use the following sequence to save a Rundown or Trace file.
Insert a USB memory stick into the USB port on the bottom of the QB Expert Alpha controller. Use the down
arrow to select the Name field. Use the Toggle button to enter edit mode. Use the left arrow to delete the name.
Use the up/down arrows or the numeric keypad to write a new file name if required. Press the interactive OK
button or the Toggle button to accept the file name.
Press again to save the file to the USB memory stick.
Press the interactive EXIT button to return to the Run screen.
2.7.7.1 Fastening Cycle Details
Press the interactive DETAILS button or the Toggle button after selecting a data line
to display the details.
Details about the event and when it occurred are listed.
Rundown ID: The sequential number of the fastening cycle data
Date: The date the fastening cycle was ran.
Time: The time the fastening cycle completed.
Job: The active Job number in which the fastening cycle ran.
Task: The active Task number in which the fastening cycle ran.
Status: The overal status of the fastening cycle.
Not all items are shown
To Next Page
Loading...
Need help?
General
