CABLE
HANDRAIL
INSERT
RUBBER
GASKET
BOLT
5
Locate the side handrails. Remove and place aside the four screws (two per side) that are
on
the
stub sticking out
of
the upper end
of
the side handrails. Slide the side handrails stub into the front
handrail, replace the four screws (two per side), and tighten loosely. Note:
If
the holes do not line
up, loosen the lower
pair
of
screws and rotate the stub
in
the side handrail until they do line up.
Attach the side rails to the side
of
the frame, inserting two bolts (3/8-16 x 4.0", SHCS), one per
side, through the side handrails and the frame. Connect the bolts to two nuts (3/8-16, NylokHex)
one per side. Tighten all bolts and screws.
§TAR
TRAC
3900
TREADMILL
Owner's
Manual
To Next Page
Loading...
