47
BEFORE INSTALLATION
Follow these guidelines to avoid injury:
- The method of drive installation must endure stress-free operation
- The drive must not move on the shaft
- The installation conditions for the drive must consider the stability and resistance
to forces associated with the door operation.
To avoid damage ensure that:
- The drive to be installed is functional and undamaged,
- The ambient temperature at the installation and target operation site
is from -20 °C to + 60 °C,
- The altitude of the location does not exceed 1000 m above sea level,
- No higher protection rating than IP54 is required.
Before starting the installation ensure that:
- the drive is not stuck,
- the drive has been properly assembled,
- all electrical systems have been properly prepared,
- there are no other sources of hazard,
- the site of installation has been protected against third-party access.
To Next Page
Loading...