52
BASIC FUNCTIONS OF THE CONTROLLER
FUNCTION POSITION DESCRIPTION
Short
press:
The “AUTO CLOSE” only can be activated when the Photo
beam or light curtain has been correctly installed and the
photo beam function has been enabled from function
menu.
- Short press the “AUTO CLOSE” button, when the
indicator light is turned on. It means the “AUTO CLOSE”
function has been activated.
(Default: The door only can auto close while in the open
limit position. And the Auto Close time is 15 seconds).
Refer to page 16 - Menu 4 to change any setting for
AUTO CLOSE conditions or time if necessary.
If there is no any photo beam or light curtain instal-
led, the door can not be closed, and the LED display will
show the letter “E6” as an indication.
- Short press the “AUTO CLOSE” button, when the
indicator light is turned o. It means the “AUTO CLOSE”
function has been dis-activated.
FORCE
Short press: - Short press the button, the digital display will indicate
the current force level rstly
- Continually short press the button: Incremental rolling
display the force level between
L 1 to L 9
COUNTER
Long press
the button
for
6 seconds:
The digital will rolling display
=
OO OO 1O, it represents the drive has been 10
running cycles worked.
RESET TO
Long press
the button
for 10 se-
conds:
- The digital will rolling display
F
-
F
=
F then release the button, it means the drive
has been restored to factory setting.
Note: The running cycle counter record will not been
cleared.
To Next Page
Loading...