Steca coolcept3 - Settings

n Network: Network parameters, partially configurable under
Settings ▶ Network
– Host name: Unique name in the network
– DHCP status: DHCP on/off
– Link status: Status of the network connection
– IP address: IP address of the inverter
– Subnet mask: Subnet mask of the inverter
– Gateway: IP address of the network gateway
– DNS address: IP address of the DNS server
– MAC address: Hardware address of the inverter
n Results of the last self-test (only if in the country setting Italy is
set)
3.3.3 Settings
When performing numerical settings of remuneration and dates, the
following applies:
Remuneration
n P
ossible currencies: £ (Pounds), € (Euros), kr (Krones), none.
n The maximum value that can be set for remuneration is limited
for technical reasons. The remuneration must be set using dif-
ferent units as required. Example: Dollars instead of Cents (set
currency to none ).
①
Designation of the numerical setting
②
Value to be set; the selected value to be set is highlighted in
black.
Date
When setting the month/year
, a check is performed to ensure that
the selected day is valid. If not, then the day is automatically cor-
rected.
Example: 31.02.2011 is corrected to 28.02.2011.
Selection of the measurements to be shown in the status display.
The following measurements can be selected:
n Output power: Inverter output power
1)
n Current day yield: Day yield since 0:00
n PV voltage: The voltage supplied by the PV generators
n PV current: The current supplied by the PV generators
n Grid voltage: V
oltage at the inverter connection
1)
n Grid current: The current fed into the mains grid
n Grid frequency: The frequency of the public grid
n Internal temperature: Internal temperature of the inverter
n Derating Reason for derating
2)
n Max. daily power: The maximum power supplied in the cur-
rent day
3)
n Abs. max. power: The maximum power ever fed into the
grid
3)
Numerical settings
Selection of the measure-
ments
EN
750.661 | Z03 | 2016-09-12 16