52
Editing
Editing Layers
Sync Mode
You can sync the LFO to the tempo of the host application. The behavior of the
Frequency parameter changes with the option you select:
Retrigger Mode
This defines whether the LFO is restarted when a note is triggered. The waveform
restarts at the position you set with the Phase parameter. The polyphonic and
monophonic LFOs offer different Retrigger settings.
The polyphonic LFOs can only switch between Retrigger On and Off:
The monophonic LFOs offer the following modes:
Frequency
This controls the frequency of the modulation, i. e. the “speed” of the LFO. When Sync
is activated, the frequency is set in fractions of beats.
Phase
This sets the initial phase of the waveform when the LFO is retriggered.
Rnd (Random)
When this is activated, each note starts with a randomized start phase. The Phase
control is automatically disabled.
Option Description
Off Select this to adjust the speed of the modulation in Hertz.
Tempo + Retrig Select this to adjust the speed of the modulation in fractions of
beats, for example, 1/4, 1/8, etc. You can also set dotted and triplet
note values. The restart behavior of the LFO depends on the
Retrigger setting.
Tempo + Beat Select this to adjust the speed of the modulation in fractions of
beats, for example, 1/4, 1/8, etc. You can also set dotted and triplet
note values. The LFO restarts with the transport of the host and
lines up to the beats of the song. The Retrigger setting does not
come into effect.
Option Description
Off The LFO runs freely.
On The LFO restarts with each note that is triggered.
Option Description
Off The LFO runs freely.
First Note The LFO restarts when a note is triggered and no other notes are
held.
Each Note The LFO restarts each time a note is triggered.
To Next Page
Loading...