55
Editing
Editing Layers
• To reset the level of a step to 0 %, [Ctrl]/[Command]-click the step.
• To reset all steps, [Shift]-[Ctrl]/[Command]-click in the graphical editor.
• To adjust all steps at once, [Shift]-click and drag a step.
• To draw a ramp with steps, hold down [Alt]/[Option] and draw a line.
• To draw symmetric ramps, hold down [Shift]-[Alt]/[Option] and draw a line.
You can adjust the steps by using the computer keyboard:
• Use the Step text field to select a certain step.
• To set the level of the selected step, enter the new value in the level text field.
• To increment or decrement the selected step, use the up and down arrow keys.
By default, the increment or decrement is in steps of 1 %. Hold [Shift] to increment
or decrement the selected step in steps of 0.1
%.
While the graphical editor has the keyboard focus, you can use the left and right arrow
keys to select the previous or next step.
Steps
Here, you set the number of steps the sequence plays.
Sync Mode
By setting a note value, you can synchronize the steps to the tempo of the host
application. Alternatively, you can specify a frequency at which the sequence repeats.
If you can set a note value or a frequency depends on the option you select here:
Frequency
When Sync mode is set to “Off”, this controls the speed at which the sequence
repeats.
Note
When Sync mode is set to one of the tempo settings, this adjusts the length of the
steps in fractions of beats.
Triplets
By activating the T button, the note values you set with the Note parameter become
triplets.
Option Description
Off Select this to adjust the speed at which the sequence repeats in
Hertz. Whether the sequence restarts when you play a note depends
on the selected Retrigger mode.
Tempo + Retrig Select this to adjust the length of the steps in fractions of beats, i. e.
1/4, 1/8, etc. The speed of the modulation depend on the number of
steps, the note value and the tempo you set in your host application.
By activating the T button, the note values become triplet note values.
Whether the sequence restarts when you play a note depends on the
selected Retrigger mode.
Tempo + Beat Select this to adjust the length of the steps in fractions of beats, i. e.
1/4, 1/8, etc. The speed of the modulation depend on the number of
steps, the note value and the tempo you set in your host application.
By activating the T button the note values become triplet note values.
The sequence restarts with the transport of the host and lines up to
the beats of the song. The Retrigger setting does not come into
effect.
To Next Page
Loading...