stellar labs 7630 - General Installation

Page 8 | Stellar
®
7630 Telescopic Crane Owner’s Manual PN: 106864
Installer Notice
According to Federal Law (49 cfr part 571), each nal-stage manufacturer shall complete the vehicle in
such a manner that it conforms to the standards in e󰀨ect on the date of manufacture of the incomplete
vehicle, the date of nal completion, or a date between those two dates. This requirement shall,
however, be superseded by any conicting provisions of a standard that applies by its terms to vehicles
manufactured in two or more stages.
Therefore, the installer of Stellar
®
Cranes and Bodies is considered one of the manufacturers of the
vehicle. As such a manufacturer, the installer is responsible for compliance with all applicable federal and
state regulations. They are required to certify that the vehicle is in compliance with the Federal Motor
Vehicle Safety Standards and other regulations issued under the National Tra󰀩c and Motor Vehicle Safety
Act.
Please reference the Code of Federal Regulations, title 49 - Transportation, Volume 5 (400-999), for
further information, or visit http://www.gpoaccess.gov/nara/index.html for the full text of Code of Federal
Regulations.
General Installation
This chapter is designed to serve as a general guide for the installation of a Stellar 7630 Crane on a Stellar
Service Body. Each installation is considered unique so certain portions of this chapter may or may not
apply to your direct application. If a question should arise during the installation process, please contact
Stellar Customer Service at (800) 321 3741.
This crane is designed for use with a Stellar Service Body installed on a vehicle that meets the minimum
chassis requirements of the crane. It is the installer’s responsibility to assure that the crane is mounted on
a platform that will support the maximum crane rating of this crane.
NOTICE
When installing welder units to the service bodies, it is highly recommended that a surge protector
is installed on the chassis batteries to protect the crane radio receiver, wiring and other electronic
devices from an unexpected electrical spike or surge. Failure to do so could result in extensive
damage to the service body and crane electrical circuit.
WARNING
Do not install this crane on a body not capable of handling the loads imposed on it. Failure to do
so may result in serious injury or death.