Stiga RS100 - Sponge Filter Element Maintenance

page 22
Release 00 - 03/2018
Engine RS100 - RSC100
Service manual
7. INTAKE SYSTEM
7.1a. Maintenanceofspongelteringelement (
model RS100)
1 - Remove the cover [
7.1] and remove the
lter element (1).
WARNING: Close the intake duct to prevent
the entry of foreign objects.
2 - Check carefully that the element has no holes
or tears, and replace it, if damaged.
 WARNING:Thelterelementmustbekept
clean and oil soaked and must be replaced if bro-
ken, cut or if it is crumbling.
Donotusecompressedairtocleanthelterele-
ment.
3 - Wash the lter element with water and detergent
and dry with a clean cloth.
4 - Pour two spoons of clean motor oil onto the
element and wring the sponge repeatedly until the
oil is evenly spread.
5 - Remove any excess oil with a clean cloth.
6 - Replace the lter element as shown in points 6
and 7 of the paragraph [ 7.1].
1
<< BACK >>
INDEX