Stihl FS 240 - Page 74

73FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
Installation
– Lubricate the entire length of the
starter post with STIHL gear
lubricant, b 14
– Install starter rope in rope rotor,
b 8.5
: Orient inner anchor loop (arrow)
so that it rests against the base of
the starter post
: Orient rope rotor (1) so that the
recess (2) engages the inner
anchor loop (arrow)
The recess in the hub of the rope
rotor acts as carrier for the anchor
loop.
: Fit the rope rotor (1) on the starter
post so that the recess of the
rope rotor engages the anchor
loop
5904RA196 TG
1
2
5904RA197 TG
1
: Insert the carrier (1) in the spring
housing so that the recess
(arrow) engages the anchor loop
(2)
: Fit washer (1)
: Slide circlip (2) into the lower
groove (arrow) of the starter post
– Install pawls and spring, b 8.3
– Tension the rewind spring, b 8.6
– Grease the pegs of the pawls,
b 14
– Reassemble remaining parts in
reverse order
5904RA198 TG
2
1
5904RA199 TG
1
2
8.5 Starter rope / starter grip
– Remove starter, b 8.2
– Relieve the tension of the rewind
spring,
b 8.4
The rewind spring will not be under
tension if the starter rope is broken.
– Remove ErgoStart/rope rotor,
b 8.4
– Remove any remaining rope from
the rope rotor if necessary
The starter rope must not be
shortened.
: Make the illustrated knot in the
end of the rope at the rope rotor
5904RA231 TG