Stihl MH 600.1 - Removing the Hoes; Attaching the Blade Spur; Attaching the Front Wheel

0478-404-9807-A
49
English 6 Assembling the Cultivator
► Push folding retainers (3) through the bores in drive
shaft (2) and close the securing clips.
Hoes (1) are secured.
6.1.2 Removing the Hoes
► Stop the engine.
► Pull out the folding retainers.
► Remove the hoes.
► Push the folding retainers through the bores in the drive
shaft.
The folding retainers are kept in place.
6.2 Attaching the Blade Spur
► Screw nuts (1) onto bolts (2) and screw into the bores in
adapter (3).
► Fit blade spur (4) into adapter (3) from below so the bores
on adapter (3) align with the lowermost bore on blade
spur (4).
► Insert pin (5).
► Push retaining pin (6) through the bore in pin (5).
► Insert the adapter with attached blade spur (7) into
mount (8) on the tiller.
► Insert pin (9).
► Push retaining pin (10) through the bore in pin (9).
The blade spur is secured.
6.3 Attaching the Front Wheel
► Slide front wheel (1) onto frame (2) so the bores align.
► Insert bolt (3) into the rear bore.
► Place washer (4) on bolt (3).
► Screw on nut (5) and tighten.