0478-404-9807-A
50
English
6 Assembling the Cultivator
► Insert pin (6) through the front bore.
► Push retaining pin (7) through the bore in pin (6).
Pin (6) is secured and front wheel (1) is locked in position.
The front wheel must not be dismantled again.
6.4 Attaching the Handlebar
► Fit lower handlebar (1) onto mount (2) and align locating
lug (3) with centre position (4).
► Screw in screw (5).
Lower handlebar (1) is locked in place.
► Push anti-dust protection (6) downwards so that locating
lug is covered.
► Press lever (7) downwards and hold.
► Insert upper handlebar (8) through lower handlebar (1)
from below using bolts (9).
► Release lever (7) and allow upper handlebar (8) to
engage at centre detent (10).
► Attach upper handlebar (8) with washers (11) and
nuts (12).
► Tighten nuts (12) to 20 Nm to 25 Nm.
Upper handlebar (8) is locked in place.
The handlebar must not be dismantled again.
To Next Page
Loading...
