0478 404 8805 A - EN
18
● Place cover (N) and coupler (M) on
drive shaft (1).
● Tighten the locking screw on
coupler (M).
● Position hoe (B2) so that the bores in
the shaft mount and the drive shaft
align.
● Push hoe (B2) onto the drive shaft.
● Insert folding retainer (L) through the
bore and close the securing clip.
7.4 Installing the running wheels
The running wheels are installed in the
same way as the hoes.
7.5 Installing the transport wheel
● Tilt the basic unit back slightly with the
help of a second person and hold it.
● Fasten transport wheel (O) at the rear
bore with bolt (U5), washer (V6) and
nut (W6).
● Additionally secure transport wheel (O)
with pin (X2) and spring clip (Y).
7.6 Installing the brake spur
● 1 Fasten bolts (U1) to brake spur
mount (F) using nuts (W1).
The hoe is marked with a sticker
(L - left).
To Next Page
Loading...
