ENFR
25
0478 404 8805 A - EN
● Install axle mount (T) on running
wheel (S) using bolts (U9),
washers (V2), spring washers (V7) and
nuts (W2).
8.1 On/Off switch
The On/Off (1) switch has the following
functions:
1 Switching on:
The On/Off switch (1) serves as the main
switch when starting the engine. The
engine cannot be started if the On/Off
switch (1) is not turned to I.
2 Switching off:
The engine switches off if the On/Off
switch (1) is turned to O.
8.2 Throttle lever
The engine speed can be controlled via
the throttle lever.
Engine speed control:
● Adjust throttle lever (1) when the engine
is running.
8.3 Drive control lever
The machine has two forward drive
speeds (slow forward and fast forward) as
well as reverse drive. They are set via the
drive control lever.
Move drive control lever (1) to the front or
rear as appropriate to the required drive.
Drive settings:
8. Controls
Engine speed:
Fast
Slow
Symbol Drive
0/R Idling/reverse
drive
1 Slow forward
drive
2 Fast forward drive
Attention!
Select drive settings only when the
gearbox has come to a standstill
and the self-propulsion lever is not
actuated. (Ö 8.4)
To Next Page
Loading...
