0478 404 8805 A - EN
26
Drive control lever is in the 0/R position:
This setting is selected when starting the
engine or when keeping the tiller stationary
with the engine running or also when using
the PTO (Ö 9.1).
Drive control lever is in the 1 position:
This setting is selected for slow forward
drive.
Drive control lever is in the 2 position:
This setting is selected for fast forward
drive.
8.4 Self-propulsion lever
The drive is engaged or disengaged by
actuating the self-propulsion lever when
the engine is running – the drive shaft
begins to rotate or is stopped.
When the self-propulsion lever is actuated
and with the hoes and running wheels
installed, the tiller moves upon contact with
the ground.
The self-propulsion lever is mechanically
locked for safety reasons. This prevents
inadvertent actuation. (Ö 10.1)
Actuating the self-propulsion lever:
● 1 Press release lever (1) to the stop
and hold.
● 2 Press self-propulsion lever (2)
quickly to the stop and hold.
● Release release lever (1).
The drive is engaged and the drive
shaft rotates.
● 3 Disengage the drive:
Release self-propulsion lever (2).
8.5 Reverse drive lever
The reverse drive is engaged or
disengaged by actuating the reverse drive
lever when the engine is running.
To set fast forward drive, press the
drive control lever to the left and
then push it forwards.
Avoid damage to the machine!
Actuate the self-propulsion lever
quickly and promptly. Do not dwell
in the half-pressed position.
To Next Page
Loading...
