ENFR
31
0478 404 8805 A - EN
12.2 Height adjustment of the upper
handlebar
The height of the upper handlebar can be
adjusted to five different settings.
● Firmly grasp upper handlebar (1) at
handle (2) with one hand and hold.
● With the other hand, push release lever
(height adjustment) (3) downwards and
hold.
● Set upper handlebar (1) to the required
position.
● Allow release lever (height
adjustment) (3) to engage fully upwards
and ensure that the upper handlebar is
fastened.
12.3 Lateral adjustment of the
handlebar
● The handlebar (1) can be adjusted
laterally to three different positions.
(Ö 8.6)
12.4 Transport wheel
With the aid of the transport wheel in the
transport position, the tiller can be
transported by pushing or pulling (lifting
slightly).
Transport wheel in transport position:
● Install transport wheel (1) as shown.
● To transport the tiller, hold the machine
firmly at the handles with both hands
and lift.(Ö 14.1)
Transport wheel in working position:
● Detach spring clip (1) and pin (2) from
transport wheel (3).
Danger of crushing!
There is a danger of pinching when
actuating the release lever (height
adjustment).
Pay attention to moving parts!
Risk of injury!
If the transport wheel is in the
working position (folded upwards)
and the pin and spring clip are not
fitted, the transport wheel may fall.
Danger of crushing!
Danger of pinching when changing
the position of the transport wheel.
Pay attention to moving parts!
To Next Page
Loading...
